Replacement Accessories Kit for Roomba 700 Series
Suitable for iRobot Roomba 700 Accessories Series (720 750 760 765 772 770 772e 774 775 776 776p 782 782e 785 786 786p 790 780) Vacuum cleaning robots.
Each Package Includes One Set of 13: 6x Filters; 3 x 3-Armed Side Brush; 1 x Bristle Brush; 1 flexible brush x Whisk; 2 x Cleaning Supplies (Screw will be presented as a gift!)
For best results, these replacement filters should be replaced every 2 or 3 months. For use with iRobot Roomba 700 Series and roomba 780 760 774
How to clean the Irbabot Roomba replacement brushes: 1.Remove the brush guard by lifting both yellow tabs. 2. Remove and clean under the yellow brush covers and remove the hair and dirt from the shafts of the brush cover. metal.
The filters maintain Roomba’s cleaning performance while reducing the infiltration of dust, pollen and other allergens into the air you breathe.
Buy from Amazon:
Size:Roomba 700 Series
How to Cleaning the Roomba 700 series brushes?
– Remove the brush guard by lifting both yellow tabs.
-Remove and clean under the yellow brush caps and remove hair and debris from the metal brush cap shafts.
– Reinstall the brush bearings and brushes, and then close the brush guard. Why we need kow the Roomba 700 series care procedure.
About Bin:Ensure proper insertion of the bin each time, as Roomba will not run without it.
About Brushes :
1 Remove brush guard by lifting both yellow tabs.
2 Remove and clean the two brushes and brush bearings.
3 Use the included cleaning tool to remove hair easily from the bristle brush by pulling it over the brush.
4 Charging Contacts,Clean the charging contacts by wiping the charging contacts on the Home Base and robot with a clean, dry cloth.
5 Cliff Sensors,Simply wipe all six cliff sensor openings with a clean, dry cloth.
Remove the filter and shake off debris by tapping the filter against your trash container as needed.
Do not expose the filters to water. This can cause damage to your robot and will void your warranty.
7 Front Caster Wheel
Front caster wheels that are clogged with hair and debris could result in floor damage. Use the following procedure to maintain the front caster wheel.
1 Pull firmly on the front wheel to remove it.
2 Remove any debris from inside the wheel cavity.
3 Remove the wheel from its housing and wipe clean. Pull firmly to remove the axle and clear any debris or hair wrapped around it.
4 Reinstall all parts when finished. Make sure the wheel clicks right back into place.
about Side Brush, To clean the side brush, use a small Phillips screwdriver to remove the screw from the center. Remove the brush, clean, reinstall.
Full Bin Sensors
Remove the bin and wipe the two optical bin sensors with a clean, dry cloth,Models 770 and above.